Laser Optics
SM 3-17 G133
Replacement
Adjustment
This bracket protects a capacitor on the unit. If the bracket is removed too early,
you could break the capacitor on the corner of the main frame when you install the
new unit.
Preparing the new laser optics housing unit
1. Shutter [A] of the laser optics housing unit ( x 3)
2. Polygon motor cover [B] of the laser optics housing unit ( x 4)
3. Sponge padding [C]
4. Tag [D]
5. Reinstall the polygon motor cover [B].
Before removing the old laser optics housing unit
Do the following settings before removing the laser optics housing unit. These are
adjustments for skew adjustment motors in the laser optics housing unit.
To Next Page
Loading...
