Ricoh G133 - Ih Coil Unit

Fusing
G133 3-88 SM
3.10.20 IH COIL UNIT
 Do not push the thermostats on the IH coil unit. If you do, the thermostats will be
opened. In that case, the IH coil unit must be replaced.
1. Fusing unit ( "p.3-3 "Fusing Unit"")
2. Operation panel cover ( "p.3-3 "Operation Panel"")
3. Image transfer belt unit ( "p.3-3 "Image Transfer Belt Unit"")
4. Paper exit cover ( "p.3-3 "Paper Exit Cover"")
5. Output Tray ( "p.3-3 "Output Tray"")
6. All PCUs ( "p.3-3 "PCU"")
7. Rear cover ( "p.3-3 "Rear Cover"")
8. Right rear cover ( "p.3-3 "Right Rear Cover"")
9. Open the controller box ("p.3-3 "Controller Box"").
10. Second duct ( "p.3-3 "Second Duct Fan"")
11. Fusing duct ( "p.3-3 "Fusing Fan"")
12. IH inverter ( "p.3-3 "IH Inverter"")
13. IH inverter bracket [A] ( x 3)
14. Remove the ground cable [B] ( x 1)