Ricoh G133 - Installation Procedure; Unpacking

Printer Installation
SM 1-7 G133
Installation
1.3.3 INSTALLATION PROCEDURE
 Remove the tape from the development units before you turn the main
switch on. The development units can be severely damaged if you do not
remove the tape.
Put the machine on the paper tray unit or the LCT first if you install an optional paper tray
unit or the optional LCT at the same time. Then install the machine and other options.
 Keep the shipping retainers after you install the machine. You may need them in
the future if you transport the machine to another location.
Unpacking
 When lifting the machine, use the handle and grips on both sides of the machine.
 If not, the machine could be dropped. This may cause an injury and may damage
the machine.
1. Pull out the handle [A].