Ricoh G133 - Service Program Mode; Entering the Service Mode; Service Mode Operation

Service Program Mode
SM 5-1 G133
Service
Tables
5. SERVICE TABLES
5.1 SERVICE PROGRAM MODE
 Make sure that the data-in LED () is not on before you go into the SP mode. This
LED indicates that some data is coming to the machine. When the LED is on, wait
for the printer to process the data.
5.1.1 SERVICE MODE OPERATION
 The Service Program Mode is for use by service representatives only. If this mode
is used by anyone other than service representatives for any reason, data might
be deleted or settings might be changed. In such case, product quality cannot be
guaranteed any more.
Entering the Service Mode
 If you switch the machine off, any jobs stored on the hard disk using the sample
print and protected print features will be deleted.
 Check first with the user tools to see if there are any jobs stored with these
features (Menu key - Sample Print, or Protected Print).
Method 1:
1. Turn the machine on while pressing the “Online” key and “Escape” key together for five
seconds or more.
2. "[SP mode (Service)]” shows on the display.
 If you switch the machine off, any jobs stored on the hard disk using the sample