Ricoh G133 - Cleaning for ID Sensors

Paper Transfer
SM 3-45 G133
Replacement
Adjustment
2. Open the right door.
3. Fusing unit ( "p.3-3 "Fusing Unit"")
4. Image transfer belt unit ( "p.3-3 "Image Transfer Belt Unit"")
5. ID sensor unit [A] ( x 2,  x 2, = x 1)
6. ID sensor board [B] ( x 6)
Cleaning for ID sensors
ID sensors must be cleaned when you visit the customer to service the machine. Do the
following steps for ID sensor cleaning.
1. K PCU ( "p.3-3 "PCU"")
2. Fusing unit ( "p.3-3 "Fusing Unit"")
3. Image transfer belt unit ( "p.3-3 "Image Transfer Belt Unit"")
4. Slide the ID sensor shutter [A] to the left side.
5. Clean the ID sensors keeping the ID sensor shutter to the left.