Ricoh G133 - Toner Pump Unit; When Reinstalling the Third Duct Fan

Image Creation
SM 3-29 G133
Replacement
Adjustment
7. Third duct fan [B] (hook x 1)
8. Third duct [C] ( x 1)
When reinstalling the third duct fan
Make sure that the third duct fan is installed with its decal facing to the upper side of the
machine.
3.6.4 TONER PUMP UNIT
There are four pump units inside the machine. This procedure describes the replacement
procedure only for one unit. If you need to replace another unit, do the same as this
procedure.
 Put some sheets of paper on the floor before doing this procedure. Toner may fall
on the floor.
1. Front door ( "p.3-3 "Rear Cover"")
2. Image transfer belt unit ( "p.3-3 "Image Transfer Belt Unit"")