Service Mode Table
G133 5-34 SM
011 Thick 2&FINE: C *ENG
012 Thick 2&FINE: Y *ENG
[Charge AC Voltage] Charge Roller AC Voltage Adjustment
(Paper Type, Color)
Paper Type –> Plain, Thick 1, Thick 2
2006
Adjusts the AC component of the charge roller bias in the various print modes.
Charge bias (AC component) is adjusted by environment correction
(SP2-007-xxx to SP2-011-xxx). These SPs are activated only when SP2-012-1
is set to "1: manual control".
001 Plain: Bk *ENG
002 Plain: M *ENG
003 Plain: C *ENG
004 Plain: Y *ENG
005 Thick 1: Bk *ENG
006 Thick 1: M *ENG
007 Thick 1: C *ENG
008 Thick 1: Y *ENG
009 Thick 2&FINE: Bk *ENG
010 Thick 2&FINE: M *ENG
011 Thick 2&FINE: C *ENG
012 Thick 2&FINE: Y *ENG
[0 to 3 / 2.1 / 0.01 KV/step]
[Charge AC Current: LL] Charge Roller AC Current Adjustment for LL
(Color)
2007
Displays/sets the AC current target of the charge roller for LL environment (Low
To Next Page
Loading...
