Service Mode Table
SM 5-51 G133
Service
Tables
196 Area0: Y *ENG Not used
197 Area1: Y *ENG
198 Area2: Y *ENG
199 Area3: Y *ENG
200 Area4: Y *ENG
201 Area5: Y *ENG
202 Area6: Y *ENG
203 Area7: Y *ENG
204 Area8: Y *ENG
Adjusts the area magnification for LD 0.
[–256 to 255 / 0 / 1 sub-dot/step]
205 Area9: Y *ENG
206 Area10: Y *ENG
207 Area11: Y *ENG
208 Area12: Y *ENG
Not used
[Area Shad. Correct. Setting] FA
2152
Adjusts the area correction value for each LD power.
The main scan is divided into 16 areas. However, the image areas are limited
from area 1 to area 14.
For BK and Magenta, area 1 is at the rear side of the machine (left side of the
image) and area 14 is at the front side of the machine (right side of the image).
For Cyan and Yellow, area 1 is at the front side of the machine (right side of the
image) and area 14 is at the rear side of the machine (left side of the image).
001 Area 0: Bk *ENG
This is for the synchronizing detection
board.
002 Area 1: Bk *ENG
003 Area 2: Bk *ENG
[50 to 150 / 100 / 1 %/step]
To Next Page
Loading...
