Service Mode Table
G133 5-68 SM
Adjusts the fixed LD power for each line speed and color.
These SPs are activated only when SP3-041-002 is set to "0".
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Plain: Bk *ENG
002 Plain: M *ENG
003 Plain: C *ENG
004 Plain: Y *ENG
005 Thick 1: Bk *ENG
006 Thick 1: M *ENG
007 Thick 1: C *ENG
008 Thick 1: Y *ENG
009 Thick 2&FINE: Bk *ENG
010 Thick 2&FINE: M *ENG
011 Thick 2&FINE: C *ENG
012 Thick 2&FINE: Y *ENG
[0 to 200 / 100 / 1%/step]
Increasing this value makes the image
density darker.
[Development DC Bias] Development DC Bias Adjustment
2229
Adjusts the development bias.
Development bias is automatically adjusted during process control; therefore,
adjusting these settings has no effect while Process Control (SP3-041-001
Default: ON) is activated.
After deactivating Process Control with SP3-041-001, the values in these SP
modes are used for printing.
Plain: 205 mm/sec, Thick 1: 115 mm/sec, Thick 2&Fine: 77 mm/sec
001 Plain: Bk *ENG
002 Plain: M *ENG
[0 to 700 / 550 / 10 –V/step]
To Next Page
Loading...
