Service Mode Table
G133 5-220 SM
[0 or 1 / 0 / 1 / step]
0: Disabled, 1: Enabled
066
Job Spooling Clear:
Start Time
Treatment of the job when a spooled job exists at
power on.
0: ON (Data is cleared)
1: OFF (Automatically printed)
069
Job Spooling
(Protocol)
Validates or invalidates the job spooling function for
each protocol.
0: Validates
1: Invalidates
bit0: LPR
bit1: FTP
bit2: IPP
bit3: SMB
bit4: BMLinkS
bit5: DIPRINT
bit6: sftp
bit7: (Reserved)
090
TELNET (0: OFF 1:
ON)
Enables or disables the Telnet protocol.
[0 or 1 / 1 / – ]
0: Disable, 1: Enable
091 Web (0: OFF 1: ON)
Enables or disables the Web operation.
[0 or 1 / 1 / – ]
0: Disable, 1: Enable
145
Active IPv6 Link
Local Address
This is the IPv6 local address link referenced on the
Ethernet or wireless LAN (802.11b) in the format:
"Link Local Address" + "Prefix Length"
The IPv6 address consists of a total 128 bits
configured in 8 blocks of 16 bits each.
147
Active IPv6
Stateless Address 1
149 Active IPv6
These SPs are the IPv6 status addresses (1 to 5)
referenced on the Ethernet or wireless LAN (802.11b)
in the format:
To Next Page
Loading...
