Service Mode Table
G133 5-230 SM
1: POP3, 2: IMAP4, 3: SMTP
013 POP Auth. Encrypt
Encrypts or does not encrypt passwords for
POP3/IMAP4 authentications.
[0 to 2 / 0 / 1/step]
0: Automatic, 1: Not encrypt, 2: Encrypt
014 POP Server Port No.
Specifies the port number of the POP server.
[1 to 65535 / 110 / 1/step]
015 IMAP Srv Port No
Specifies the port number of the IMAP4 server.
[1 to 65535 / 143 / 1/step]
016 SMPT Rx Port No
Sets the receiving port number for receiving an
e-mail from the SMTP.
[1 to 65535 / 25 / 1 /step]
017 Receive Interval
Specifies the interval for receiving an e-mail.
[2 to 1440 / 3 / 1 min/step]
019 Mail Keep Sett.
Sets the mail type kept in the mail server after
receiving an e-mail.
When you set the "1", all e-mails are kept in the
mail server after receiving an e-mail. When you
set the "2", only error mails are kept in the mail
server after receiving an e-mail. When you set the
"0", no e-mail is kept in the mail server after
receiving an e-mail.
[0 to 2 / 0 / 1 /step]
0: No keep, 1: All, 2: Error mail
020 Partial Mail Receive Timeout
[1 to 168 / 72 / – ]
Sets the amount of time to wait before saving a mail that breaks up during
reception. The received mail is discarded if the remaining portion of the mail is
not received during this prescribed time.
021 MDN Response RFC2298 Compliance
[0 to 1 / 1 / – ]
Determines whether RFC2298 compliance is switched on for MDN reply mail.
To Next Page
Loading...
