Ricoh G133 - Page 660

Firmware Update
G133 5-338 SM
35
Module mismatch – Module
on SD card is not for this
machine
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
36
Cannot write module –
Cause other than E34, E35
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.
40
Engine module download
failed
Replace the update data for the module on the
SD card and try again, or replace the EGB
board.
42
Operation panel module
download failed
Replace the update data for the module on the
SD card and try again, or replace the LCDC.
43
Stamp data module
download failed
Replace the update data for the module on the
SD card and try again, or replace the hard disks.
44
Controller module download
failed
Replace the update data for the module on the
SD card and tray again, or replace controller
board.
50
Electronic confirmation check
failed
SD update data is incorrect. The data on the SD
card is for another machine. Acquire correct
update data then install again.