Tray Heater (Optional Tray)
G133 1-46 SM
6. Pull out tray 2 from the mainframe.
7. Replace the shoulder screw [E] with the washer screw [F], using securing bracket [G]
( x 1).
8. Connect the harness [H] to the connector [I] of the tray heater.
9. Route the harness [H] as shown and clamp it with four clamps (= x 4).
10. Connect the harness [H] to the connector [J] of the mainframe.
11. Reassemble the mainframe and optional paper feed unit.
To Next Page
Loading...
