3. Enter the information of the destination in the input boxes displayed on the [Name] tab,
and select the title to classify the destination.
4. Press the [Destinations] tab, and then press [Folder].
5. Select [SMB (Send to Shared Folder on PC)] in [Protocol].
6. Under [Folder Authentication Info], select [Specify Other Authentication Information] and
then enter the name and password of the login user who will access the shared folder.
7. Specify the network path to the shared folder in "Path".
Entering the path name manually
If the computer name is "YamadaPC" ([1] on the check sheet) and the shared folder name is
"shared_doc" ([4]), enter as follows:
\\YamadaPC\shared_doc
When you cannot connect to the computer using the computer name, enter the IP address ([1]
on the check sheet) and the shared folder name ([4] on the check sheet) as follows:
\\192.168.0.152\shared_doc
Selecting a folder from the list
Enter the IP address or host name of the computer on which to search for a shared folder,
press [Browse Network], and then select the destination folder.
8. Press [Connection Test]
[Exit].
• When no connection is established, check the message that appears.
page 222 "When a Message Appears While Using the Scanner Function"
• Press [Cancel] to abort the connection test, such as when you make a mistake specifying Path.
9. Press [OK].
Scanning Documents and Sending the Scanned Data to a Folder
121
To Next Page
Loading...
