Support the original with your hands until it feeds in.
• After inserting an original, do not try to handle it.
• When loading long or thick originals, use both hands to support the original as it feeds until half of
it is scanned so feeding is not interrupted.
• When placing rolled originals, use the output basket. For details, see page 56 "Placing Rolled
Originals".
• You can change the original feed delay setting if originals are repeatedly feeding in slanted, or if
you need to adjust the delay for the type of originals you are using.
• See "Machine", User Guide (Full Version).
Stopping Originals from Feeding in
If the originals are feeding in slanted, or jamming, etc., press the [Scanner Stop] key to stop them
feeding in.
• When you press the [Scanner Stop] key, the machine stops feeding the original immediately, which
can cause it to jam. When this happens, see below.
Placing Originals on the Original Table
55
To Next Page
Loading...
