Loading Paper Roll into the Paper Input Location
This section explains how to load a paper roll into the paper input location.
• Bring the paper holder flush against the paper edge to fasten the paper.
• Insert the paper holder flange securely.
• Make sure not to load a paper roll in the opposite direction. If you feed a paper roll in the opposite
direction, the paper roll may come loose or be damaged.
• Before loading the paper roll into the paper input location, remove any paper that is in the paper
bypass location.
• When the paper roll is in one of the following conditions, you cannot use it. Cut off the edge of the
paper with scissors before loading it.
• The leading edge is damaged
• Adhesive tape, glue or paste is sticking to it
• The paper is wrinkled
8. Adding Paper and Ink
144
To Next Page
Loading...
