Specifying the Length of Copy Paper Cut
Specify the length to cut the paper loaded in the paper input location. The paper loaded in the paper
input location is cut and delivered after copying.
There are three types of applications that paper cut methods as described below.
• Synchro Cut
• Preset Cut
• Variable Cut
• When you use the paper that loaded into the paper bypass location, you cannot use this function.
Synchro Cut
Cuts the paper at the same length as the original. If the copy is enlarged or reduced, the machine
calculates the appropriate length for the magnification ratio and cuts the paper.
1. Press [Copy] on the Home screen.
2. Press the paper input select key, and then select Paper Input Location 1 or 2.
3. Press [Synchro Cut].
4. Place the original.
page 57 "Basic Procedure for Copying Documents"
The original is fed into the machine automatically, and copying starts. If the original is not fed
automatically, press [Start].
3. Copy
60
To Next Page
Loading...
