Replacing an Ink Collector Unit
The ink collector unit needs to be replaced soon when the "Ink Collector Unit almost full." message is
displayed. Prepare a replacement ink collector unit.
See "Contact Information", User Guide (Full Version).
See the animation displayed on the control panel of the machine for the procedure to replace the ink
collector unit.
• When removing the ink collector unit, do not touch the inside of the machine.
• Do not touch the ink collector unit's chip contacts.
• Do not drop or tilt the ink collector unit. Doing so may result in leakage.
• Take care not to drop the ink collector unit when putting it in the supplied plastic bag. The bag
might tear, causing ink to spill.
• Push in the ink collector unit until the lever clicks. If it does not click into place, ink may leak inside
the machine.
• Do not open the ink collector unit cover other than when replacing the ink collector unit. Doing so
may result in misfeeds.
1. Replace the ink collector unit by following the procedure shown in the animation.
8. Adding Paper and Ink
192
To Next Page
Loading...
