• For details about printing the test pattern, see page 249 "Print Nozzle Check Pattern".
• For details about head cleaning, see page 250 "Clean Print-heads".
• For details about head flushing, see page 251 "Flush Print-heads".
If the Printout Is Smeared with Dots of Ink That Are 1 to 2 mm in Diameter
If your printouts are smeared by unwanted spots of ink that are about 1 to 2 mm in diameter, you need
to clean the print-heads.
Clean the print-head when you use the ink that is the same color as the spots.
If you cannot identify the color, clean all the print-heads.
• For details about head cleaning, see page 250 "Clean Print-heads".
9. Troubleshooting
248
To Next Page
Loading...
