3. Press [Send Settings] and configure the scan settings according to the purpose of the
scanned data.
See "Scanning an Original with Suitable Quality and Density", User Guide (Full Version).
page 127 "Specifying the File Type or File Name When Scanning a Document"
4. Press
, select [Search Address Book] or [Specify by Reg. No.] and then specify the
shared folder that is registered in the address book.
• To enter the information manually, press , and select [Manual Entry]. Select SMB as the
protocol and enter the required information.
• To specify the destination again, press .
5. Place the original. If scanning does not start automatically, press [Start].
page 54 "Placing Originals on the Original Table"
• If any of the machine's security functions are enabled, select the destination from the registered
folder only when you send files by Scan to Folder.
• If the firewall of an antivirus program is active, you may not be able to specify a shared folder on
the computer as a folder destination. If this is the case, see the antivirus program's Help.
• If Windows firewall is active and you cannot specify a shared folder on the computer as a folder
destination, the machine may be able to communicate with the computer by changing the
exceptions of the Windows firewall. For details, see Windows Help.
• After scan files are sent, the destination and file name fields will be automatically cleared. If you
want to preserve the information in these fields, contact your local dealer.
• When the specified destination is updated using the Central Management function, the spooled
documents are sent to the destination after updating.
Scanning Documents and Sending the Scanned Data to a Folder
123
To Next Page
Loading...
