2. Press [Paper Input Location/Paper Settings].
3. Press [Paper Size/Paper Type] [Paper Size/Paper Type].
4. Press one paper input location to set.
5. Press [Paper Size].
To specify for the paper bypass location, press [Paper Size: Printer].
6. Choose one paper size from the list shown, and then press [OK].
7. Press [OK].
8. After completing the configuration, press [Home] ( ).
To use paper that can be detected automatically after using paper that cannot be detected
automatically, restore the setting of Auto Detect. To restore the setting of Auto Detect, load the
paper again, operate steps 1 to 6, select [Auto Detect], and then press [OK].
8. Adding Paper and Ink
162
To Next Page
Loading...
