1. Original table
Place originals here scanning side down.
2. Original cover
Open to clear jammed originals.
3. Original stacker
Originals are stacked here.
4. Stacker support
Use to output originals to the front side.
5. [Scanner Stop] key
Use if originals are feeding in slanted, or to cancel scanning while an original is feeding in.
6. Paper holding lever
This lever holds paper that is inserted into the paper input location or the paper bypass location. Use this lever
to copy or print from the bypass location, or to remove misfed paper.
7. Cartridge cover
Open to replace print cartridges.
8. Ink collector unit cover
Open this cover to replace the ink collector unit. Ink used for maintenance collects in the ink collector unit.
9. Output basket
The delivered paper is stacked here.
10. Paper input location cover
Open to load the paper roll onto the paper input location or to remove misfed paper.
11. Original guide
Set to the width of your originals.
Guide to Names and Functions of Components
17
To Next Page
Loading...
