Ricoh IM CW2200

Message Cause Solution and reference
"Auto-registration of
user information has
failed."
The maximum
number of items that
can be registered
has been exceeded
and the
authentication
information for
LDAP authentication
or Windows
authentication
cannot be
registered
automatically.
Delete a user that is no longer necessary from the
address book.
"Cannot access the
Memory Storage
Device."
An SD card or USB
flash memory
device is
unavailable for use.
• Check that the external media is formatted in
FAT16 or FAT32, and write protection is not
enabled on the media.
• Check that the external media is not corrupted or
damaged.
"Collate has been
cancelled."
The sort function
was canceled.
Turn off the power of the machine, wait for 10 seconds
or more after confirming that the main power indicator
is turned off, and then turn on the power.
page 11 "Turning On and Off the Power"
"Command Error" A problem occurred
in the data because
of the
communication
status or another
reason.
Check that the machine can communicate with the
computer properly.
A printer driver that
does not support the
machine was used.
Use the printer driver for the machine. Obtain and
install the latest version of the driver.
"Compressed Data
Error."
Compressed data is
corrupted.
• Check that the tool used for creating the
compressed data is functioning properly.
• Check that the machine can communicate with the
computer properly.
When a Message Appears While Using the Printer Function
213