Ricoh M C240FW - Page 219

Troubleshoot a problem 219
Action
Yes
No
Step 3
1 Turn off the printer, wait for about 10 seconds, and then turn the
printer on.
2 Copy or scan the document.
Is the scanner responding?
The problem is solved.
Contact customer
support.
Adjusting scanner registration
1 From the control panel, navigate to:
Settings > Device > Maintenance > Config Menu > Scanner Configuration > Scanner Manual
Registration
2 Touch Print Quick Test.
3 Place the Print Quick Test page on the scanner glass, and then touch Flatbed Registration.
4 Touch Copy Quick Test.
5 Compare the Copy Quick Test page with the original document.
Note: If the margins of the test page are different from the original document, then adjust Left Margin and Top
Margin.
6 Repeat step 4 and step 5 until the margins of the Copy Quick Test page closely match the original document.
Adjusting ADF registration
1 From the control panel, navigate to:
Settings > Device > Maintenance > Config Menu > Scanner Configuration > Scanner Manual
Registration
2 Touch Print Quick Test.
3 Place the Print Quick Test page on the ADF tray.
4 Touch Front ADF Registration or Rear ADF Registration.
Notes:
• To align Front ADF Registration, place the test page faceup, short edge first into the ADF.
• To align Rear ADF Registration, place the test page facedown, short edge first into the ADF.
5 Touch Copy Quick Test.
6 Compare the Copy Quick Test page with the original document.
Note: If the margins of the test page are different from the original document, then adjust Horizontal Adjust
and Top Margin.
7 Repeat step 5 and step 6 until the margins of the Copy Quick Test page closely match the original document.