Appendix
88
9
❖ IPP timeout configuration
Specify how many seconds to wait before canceling a print job if it has been
interrupted for some reason. The time can be from 30 to 65535 seconds.
msh> ipp timeout {30 - 65535}
❖ IPP user authentication configuration
Use IPP user authentication to restrict printing with IPP to certain users. The
default is “off”.
msh> ipp auth {basic | digest | off}
• “basic” and “digest” are user authentication settings.
• “off” removes the user authentication.
Note
❒ If you select “basic” or “digest”, see next section “Configuring IPP user au-
thentication” for how to configure the user name. Up to ten user names are
available.
❖ Configuring IPP user authentication
Use the following command:
msh> ipp user
The following message appears:
Input user number (1 to 10):
Enter the number, user name, and password.
IPP user name: user1 IPP password:*******
After configuring, the following message appears:
IPP configuration changed.
Direct printing port
The direct printing port allows printing directly from a computer, connected to
the network, to the printer.
Use the “diprint” command to change direct printing port settings.
❖ View settings
The following command displays the current direct printing port settings:
msh> diprint
Example output:
port 9100
timeout=300 (sec)
bidirect off
• “Port” specifies the port number of the direct printing port.
• The “bidirect” setting indicates whether the direct printing port is bidirec-
tional or not.
To Next Page
Loading...
