Appendix
92
9
❖ Configuration
msh> wiconfig parameter
Parameter Value to be configured
mode [ap | 802.11adhoc | adhoc] You can set infrastructure mode (ap), 802.11
ad hoc mode (802.11adhoc), or ad hoc mode
(adhoc).
The default is 802.11 ad hoc mode.
ssid ID value You can set SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
SSID value is set automatically to the nearest
access point if the setting has not been made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an “ASSID” value is automatically set.
channel frequency channel no. You can set the channel.
You can specify from the following channels:
• Metric Version : 1-13
• Inch Version : 1-11
Set the same channel for all the machines you
are using.
enc {on | off} You can enable or disable the WEP function.
To enable the WEP function, select [on]; to
disable it, select [off].
To start the WEP function, enter the correct
WEP key.
key {key value} 64-bit or 128-bit can be set.
Only 10 hexadecimal characters can be set
when using 64-bit; or 26 hexadecimal charac-
ters when using 128-bit.
Also, set 0x as the prefix.
To use this function, set the same WEP key
for all ports that transmit to each other.
auth {open | shared} You can set the authorized mode when using
WEP. The specified value and the authorized
mode are as follows:
open: Open system authorized (default)
shared: Shared key authorized
To Next Page
Loading...
