Remote Maintenance by telnet
93
9
Note
❒ When changing the interface to IEEE 802.11b interface, see p.80 “TCP/IP ad-
dress”.
❒ When configuring the IEEE 802.11b interface TCP/IP, see p.80 “TCP/IP ad-
dress”.
Changing the host name
Use the “hostname” command to change the printer name.
msh hostname interface_name printer_name
*1
If you did not enter the interface name, it will be automatically set to the Ethernet in-
terface.
*2
Available when the IEEE 802.11b interface unit is installed.
Note
❒ Enter the printer name using up to 15 characters.
❒ You cannot use a printer name starting with “RNP” or “rnp”.
❒ The Ethernet interface and IEEE 802.11b interface will have the same printer
name.
rate {auto | 11m | 5.5m | 2m | 1m} You can set the IEEE 802.11b transmission
speed.
The transmission speed you specify here is
the speed at which data is sent. You can re-
ceive data at any speed.
auto: automatically set (default)
11m: 11 Mbps fixed
5.5m: 5.5 Mbps fixed
2m: 2 Mbps fixed
1m: 1 Mbps fixed
Interface name Interface to be configured
ether
Ethernet interface
*1
wlan
*2
IEEE 802.11b interface
Parameter Value to be configured
To Next Page
Loading...
