Appendix
94
9
WINS
Use the “wins” command to configure WINS server settings.
❖ Viewing setting
The following command displays the WINS server IP address:
msh> wins
Example output:
msh> wins
WINS Configuration:
interface_name:
WINS: On
primary server 0.0.0.0 secondary server 0.0.0.0
ScopeID
Current configuration:
primary server 0.0.0.0 secondary server 0.0.0.0
hostname host_name ScopeID
Note
❒ If the IP address obtained from DHCP differs from the WINS IP address,
the DHCP address is the valid address.
❖ Configuration
Use the “set” command to make WINS active or inactive.
msh> wins interface_name {on | off}
• “on” means active; “off” means inactive.
❖ Setting WINS Server Address
You can make settings for the WINS server address.
msh> wins interface_name {primary | secondary} IP_address
• “primary” is for setting the primary WINS server address.
• “secondary” is for setting the secondary WINS server address.
To Next Page
Loading...
