Remote Maintenance by telnet
95
9
❖ NBT scope ID setting
You can configure the NBT scope ID.
Limitation
❒ Enter a scope ID using up to 31 alphanumeric characters.
msh> wins interface_name scope scope_ID
Note
❒ If you receive different scope IDs from DHCP and WINS, the scope ID
from DHCP takes priority.
*1
Available when the IEEE 802.11b interface unit is installed.
AutoNet
Use the “autonet” command to configure AutoNet settings.
❖ Display
The following command displays the current AutoNet settings.
msh> autonet
❖ Configuration
You can configure the AutoNet settings.
msh> autonet interface_name [on | off]
Note
❒ Select [on] to enable AutoNet.
❒ Select [off] to disable AutoNet.
Interface name Interface to be configured
ether Ethernet interface
wlan
*1
IEEE 802.11b interface
To Next Page
Loading...
