Problem Cause Solution
• To adjust further, change the
media feed correction level using
the following procedure:
1. Press the [Standard
Procedure] key.
2. Press [Selected Setting for
Head Alignment].
3. Press [Media Feed
Correction].
4. Press [Level Setting].
5. (Only if the ink combinations
are 4C+W)
Select the print layer to
change the media feed
correction level.
6. Select the print mode to
change the media feed
correction level.
7. Select the media feed
correction level from [Level
0], [Level 1], [Level 2], and
[Level 3].
8. Press [Close] 3 times if the
ink combinations are 4C,
and 5 times if the ink
combinations are 4C+W.
9. Press [End].
The connection method for
the print heads will be
applied to the first printing
job after these settings are
configured.
When You Cannot Print as Expected
183
To Next Page
Loading...
