Ricoh Ri 2000 - Page 101

2. Printing RICOH Ri 2000 User Manual
101
2. Select the platen size attached to the printer.
IMPORTANT! If the garment is not flat, the platen height will not be set properly and will not print
properly. Be sure to flatten the garment.
Having the head too far away from the printing surface can cause poor prints in
addition to interfering with the encoder function, causing an error due to excessive
ink mist. This can also cause damage to other components due to excessive ink
mist. It is important when changing from a thicker fabric to a thinner fabric that the
height adjustment of the platen must be performed.
NOTE - “Other” is used only in special cases such as printing on media that rises in the center of
the platen.
When you select “Other”, adjusting will be based on the height of the center of Platen.
Printing can be started after the height adjustment of the platen is completed.
If there is a height difference of 3 mm or more in the set garment, an error will be displayed.
Set the garment properly flat, and then perform height adjustment again.