9. Troubleshooting Guide RICOH Ri 2000 User Manual
214
Stopping printing
If an SC error occurs during printing, stop printing.
If you cannot use the touch panel and if the platen has stopped inside the machine, turn off the machine
and pull the platen slowly to the front side of the machine by hand. Then, proceed to page 217, “Checking
the carriage position”.
CAUTION: Moving the platen fast or hard by hand could cause a malfunction.
Press [STOP].
Press [CANCEL].
The printing job is stopped and the platen returns to the front side of the machine.
Proceed to page 217, “Checking the carriage position”.
To Next Page
Loading...
