Ricoh Ri 2000 - How to do without attaching jig for head protection cover

9. Troubleshooting Guide RICOH Ri 2000 User Manual
250
How to do without attaching jig for head protection cover
If you selected "NO" in "8.Select whether or not to use the attaching jig for the head protection
cover. ([YES/NO])
" on page 238, continue with the following steps.
Open the front cover.
Press [NEXT].
[NEXT] can only be pressed with the front cover open.
Install the head protection cover filled with cleaning solution.
See “Attaching the head protection cover” on page 221 for installation instructions.
However, do not turn off the printer.
Press [NEXT].
※When canceling the maintenance at this time, detach the head protection cover and press
"CANCEL".
When [CANCEL] is pressed, the print head will be capped, and the maintenance will be completed.
However, please note that an error will occur if "CANCEL" is pressed while the head protection cover
is still attached.