9. Troubleshooting Guide RICOH Ri 2000 User Manual
251
Check that the head protection cover is securely attached to the carriage, and
press [NEXT].
If the head protection cover is not attached correctly, the inside of the machine may be stained with
ink.
After attaching the head protection cover, observe it from the front and check if the head protection
cover is not tilted. If it is tilted, a gap may be visible between the carriage and the cap inside the head
protection cover, as shown in the NG image below. In this case, perform the installation again.
※When canceling the maintenance at this time, detach the head protection cover and press
"CANCEL".
When [CANCEL] is pressed, the print head will be capped, and the maintenance will be completed.
However, please note that an error will occur if "CANCEL" is pressed while the head protection cover
is still attached.
Close the front cover.
To Next Page
Loading...
