RIGOL Chapter 7 Logic Analyzer
7-2 MSO4000/DS4000 User’s Guide
To Turn the Digital Channels On/Off
You can turn on or off all the digital channels (D0 to D15) according to your needs.
The channels are independent from one another.
Press LA On/Off to enter the “On/Off” setting menu of the digital channels. You
can set the on/off states of the digital channels using any of the following methods
via this menu.
Turn on or off channels D7 to D0 at the same time
Press D7-D0 to select “Turn On” or “Turn Off”.
Turn on or off channels D15 to D8 at the same time
Press D15-D8 to select “Turn On” or “Turn Off”.
Turn on or off a single channel
Press Sel CH and turn the multi-function knob to select the desired channel
(D0 to D15). Then, press the knob or press Sel CH to switch the on/off state of
the channel. The on/off state of the channel is displayed at the front of the
channel name; wherein,
denotes the channel is turned on and denotes
the channel is turned off.
Turn on or off the user-defined channel group
Press Group and turn the multi-function knob to select the desired group
(Group1 to Group4). Then, press the knob or press Group to switch the on/off
states of all the channels in this channel group. The on/off state of the channel
group is displayed at the front of the channel group name; wherein,
denotes
the channel group is turned on and
denotes the channel group is turned off.
Note: Only the groups that contain digital channels can be selected. For how to
group the channels, plaese refer to the instruction in “To Perform Grouping
Setting”.
Note:
The 4 setting methods mentioned above enjoy the same priority. Subsequent
operations will change the previous on/off state(s) of the channel(s).
For the channel waveform and label colors of the digital channel turned on,
please refer to “Digital Channel Waveform and Label Colors”.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
