Chapter 10 Pass/Fail Test RIGOL
MSO4000/DS4000 User’s Guide 10-1
Chapter 10 Pass/Fail Test
The Pass/Fail test function is used to monitor the change of the signal and judge
whether the instrument passes or fails the test by judging whether the input signal is
within the user-defined mask. This function is applicable to the analog channels (CH1
to CH4).
The contents of this chapter:
To Enable or Disable the Pass/Fail Test Function
To Start or Stop the Pass/Fail Test Operation
To Specify the Source
To Set the Test Mask
To Turn the Test Result Display On/Off
To Set the Output Form of Test Failure
To Save the Test Mask Range
To Load the Test Mask Range
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
