Chapter 14 System Function Setting RIGOL
MSO4000/DS4000 User’s Guide 14-9
System-related
Sound
When the beeper is enabled, you can hear the sound of the beeper when you
operate a front panel key or menu softkey or when a prompt message pops up.
Press Utility and press Sound to select (on) or (off). The default is off.
When the sound is turned on, will be displayed at the lower-right side of the
screen.
Language
This oscilloscope supports menus in multiple languages. It provides Chinese/English
help information, prompt messages and interface display.
Press Utility Language; turn the multi-function knob to select the desired
language and press the knob. You can also press Language continuously to switch
the current language type.
System Information
Press Utility System System Info to enter the system information interface.
The system information contains the manufacturer, device model, instrument serial
number, software version number and hardware version number.
Power-on Load
You can set the system configuration to be loaded when the oscilloscope is powered
on again after power-off.
Press Utility System and press Power On to select “Last” or “Default”.
Last: return to the setting of the system at last power-off.
Default: return to the factory setting of the system.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
