Chapter 15 Remote Control RIGOL
MSO4000/DS4000 User’s Guide 15-9
Remote Control via GPIB
1. Connect the device
Use the USB-GPIB interface converter to extend a GPIB interface for the
oscilloscope. Then connect the oscilloscope to your PC using a GPIB cable.
2. Install the driver of GPIB card
Install the driver of the GPIB card which has been connected to the PC correctly.
3. Set the GPIB address
Press Utility IO Setting GPIB to set the GPIB address of the
oscilloscope (refer to “To Set the GPIB Address”).
4. Search for device resources
Start up Ultra Sigma and click
to open the window as shown in figure
(a). Click
in the window and the software will search for the
instrument resources currently connected to the PC via the GPIB interface. The
instrument resources found will be displayed on the right side of the window (as
shown in figure (b)). Click
to add the resource.
(a)
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
