83
Recalling Stored Data
Changing the display
The procedure is in principle the same as for the measurement screen.
However, the VM/TIME/FFT key functions as follows.
Vibration meter mode: Key has no effect
Time waveform mode: Key has no effect
FFT mode: Toggles between graph display and list display
The steps for changing the display according to the analysis function are as
listed below.
Vibration meter mode
The ACC/VEL/DISP key can be used to change the measurement data type
(data shown as bar graph).
Time waveform mode
The display can be zoomed in or out (see pages 51 to 52).
FFT mode
The display can be zoomed in or out (see pages 69 to 70).
The cursor X axis unit, cursor Y axis unit, and FFT scale (Y axis display
scale) can be changed.
To Next Page
Loading...
Need help?
General
