GX-3R Pro Operator’s Manual Chapter 5: User Mode and Calibration • 62
BUMP SETTING
(page 92) (cont’d)
BUMP
PARAMETER
(page 92)
(cont’d)
ESCAPE Return to the BUMP PARAMETER menu item
in BUMP SETTINGS.
BUMP
REMINDER
(page 95)
ON
: The instrument notifies the user upon startup when a bump test
is due. Notification type depends on BUMP EXPIRED setting
below.
OFF
(factory setting): No notification upon startup when a bump
test is due.
BUMP
INTERVAL
(page 96)
How often the instrument needs to be bump tested.
Options: 0 - 30 days (factory setting is 30 days)
BUMP
EXPIRED
(page 96)
Defines what action must be taken if a bump test is due upon
startup.
CONFIRM TO USE
(factory setting): Press and release AIR to
acknowledge that bump test is due and continue to Measuring
Mode.
CANNOT USE
: Cannot enter Measuring Mode until a successful
bump test is performed.
NO EFFECT
: A screen indicates that bump test is due but warmup
sequence continues.
BUMP CHECK
GAS (page 97)
ALL GAS
(factory setting): Bump test dates for all gases are used
to determine if bump test is due.
4 GAS
: Bump test dates for only the standard 4 gases (combustible
gas/O
2
/H
2
S/CO) are used to determine if bump test is due.
ESCAPE Return to the BUMP SETTING menu item in User Mode.
MAN DOWN (page
99)
Turn the man down and panic alarms on and off. Set the intervals for man down
alarms.
MAN DOWN
(page 98)
ON
: Man down alarm is triggered if the instrument does not detect
motion during time period defined in WARNING 1 TIME,
WARNING 2 TIME, and ALARM TIME below.
OFF
(factory setting): No man down alarm triggered.
PANIC (page
99)
ON
: Panic alarm can be triggered.
OFF
(factory setting): Panic alarm cannot be triggered.
MAN DOWN
TIME (page 99)
ALARM TIME WARNING 2 TIME WARNING 1
TIME
Table 9: User Mode Items
User Mode
Menu Item
Description
To Next Page
Loading...
