Robopac PACK 5040M - Safety Warning for Electrical Equipment

PACK 5040M/6050M
PACK 5040A/6050A
― Take all necessary precautions (suitably mark the working area and the exits, ensure proper visibility,
provide all necessary supporting equipment, etc.) to ensure safe operation.
― Delimitate the work area to minimise the risks, as per the workplace safety and health regulations.
― Enable all machine safety devices before performing any maintenance and regulation operations.
― Maintenance work in hard to access areas shall be carried out only after having removed any existing
risks.
― DO NOT use products that contain corrosive, toxic and inflammable substances.
― Wear the Individual Protection Devices provided by the laws on workplace safety and indicated in the
"Instructions for use" and/or affixed to the machine.
― Replace the components only with original spare parts or with parts with similar design and functional
characteristics so as to kee
p
the intended safet
y
level unchan
g
ed.
― Use lubricants (oils or grease) recommended by the manufacturer or with similar chemical-physical
features.
― Do not dum
p
into the environment
p
ollutin
g
li
q
uids, worn
p
arts and maintenance waste.
― Dis
p
ose of the same in com
p
liance with current re
g
ulations on the matter.
― Select the components according to the chemical and physical features of the material and carry out
the differentiated waste dis
p
osal as
p
er the standards in force.
― Follow the
p
rocedures in this cha
p
ter.
― Non compliance with the instructions given may cause risks for safety and health of the persons and
economic dama
g
es.
2.8. SAFETY WARNING FOR ELECTRICAL EQUIPMENT
T
he electrical s
y
stem has been desi
g
ned and built in com
p
liance with a
pp
licable le
g
islation.
T
his le
g
islation also s
p
ecifies the ambient conditions re
q
uired for o
p
eration.
T
he followin
g
list s
p
ecifies ambient conditions necessar
y
to ensure correct electrical s
y
stem function.
― Ambient tem
p
erature must be between 5°C°C and 40°C.
― Relative humidit
y
must be between 50% (measured at 40°C) and 90% (measured at 20°C).
― The installation area must not be subject to or contain sources of electromagnetic interference or
radiation (X ra
y
s, laser li
g
ht etc).
―
T
he installation area must not contain
p
otentiall
y
ex
p
losive or flammable mixtures of
g
ases or dust.
― No contaminant or corrosive products (acids, chemicals, salts etc.) may be used during production and
maintenance. An
y
p
roducts used must be ke
p
t awa
y
from electrical com
p
onents.
―
T
he ambient tem
p
erature durin
g
stora
g
e must be between - 25°C and 55°C.
― Electrical equipment may be exposed to temperatures up 70°C, provided that exposure does not
exceed 24 hours.
―
T
he electrical s
y
stem will function correctl
y
u
p
to an altitude of 1000 m above sea level.
If any of the aforementioned conditions cannot be met, any additional measures necessary to
ensure safe operating conditions (e.g. special electrical components, air conditioning systems
etc.) must be defined durin
g
the contractual sta
g
e.
English
10/56