Robopac PACK 5040M - Description of the Electrical Devices

PACK 5040M/6050M
PACK 5040A/6050A
3.4. DESCRIPTION OF THE ELECTRICAL DEVICES
T
he fi
g
ure shows the
p
ositionin
g
of the devices on board of the machine.
A) E2 Resistances: allow the
p
roduction of heat inside the tunnel accordin
g
to the
p
reset tem
p
erature.
B) M3 “Tunnel drive” motor: it starts the movement of the conve
y
or in the tunnel.
C) M4 "sealin
g
belt" motor: starts movement of sealin
g
belt.
D) M5 “Turbine” motor: it starts the turbine inside the tunnel.
E) M9 "Scra
p
recover
y
" motor: starts movement of the scra
p
recover
y
unit (O
p
tional).
F) M8 Motor: activates the film o
p
enin
g
blow (O
p
tional).
G) SQ1 Limit switch: detects the closin
g
of the weldin
g
arm.
H) SQ9 “Scra
p
recover
y
” endstroke: detects the need to start or sto
p
the scra
p
recover
y
motor.
L) ST1
T
em
p
erature sensor: detects the tem
p
erature inside the tunnel.
M) V1/V2 Electroma
g
nets: allow the arm to remain
p
ressed on the Teflon.
| Important
For further details see the electrical dia
g
ram.
English
16/56