Robopac PACK 5040M - Description of the Operation Cycle

PACK 5040M/6050M
PACK 5040A/6050A
A) Base.
B) Control
p
anel.
C) Mobile
p
roduct carrier surface.
D) Sealin
g
conve
y
or.
E) Reel carria
g
e.
F) Double reel carria
g
e (O
p
tional).
G) Film o
p
enin
g
blow (O
p
tional).
H) Motorized scra
p
recover
y
coil (O
p
tional).
I) Pedal (O
p
tional) Pack 5040A - 6050A.
L) Swivel wheels (two with brake).
M) Air flow tunnel.
N) Roller carrier (O
p
tional).
O) Belt conve
y
or.
P) Idle roller conveyor (Optional)
L=500 - L=1000.
i
Danger - Warning
This machine is normally installed in workshops or industrial environments protected from the atmospheric
agents.
Use of this machine in explosive environments or when exposed to the elements is strictly forbidden.
During the operating stages just one operator is necessary to perform the infeed, cycle start and wrapped
p
roduct outfeed o
p
erations.
3.2. DESCRIPTION OF THE OPERATION CYCLE
Phase 1.
Insertion of the
p
roduct to be
p
acka
g
ed inside the double la
y
er of film.
Phase 2.
Positionin
g
of the
p
roduct on the sealin
g
conve
y
or.
Phase 3.
Manual activation of the weldin
g
arm and conse
q
uent an
g
ular weldin
g
(Model PACK 5040M-6050M).
Activate the weldin
g
arm in automatic c
y
cle (Model PACK 5040A-6050A).
Phase 4.
Product entrance inside the tunnel and retraction of the film on the
p
roduct.
Phase 5.
Product exit.
English
14/56