Robopac PACK 5040M - Technical Information; Machine General Description

PACK 5040M/6050M
PACK 5040A/6050A
3. TECHNICAL INFORMATION
3.1. MACHINE GENERAL DESCRIPTION
The L-bar sealer packaging machine in question, further referred to as the machine, is designed and built to
package various product types with spools of centre fold shrink film.
Packaging is made up of a sealing phase and a filmshrinking phase.
The machine is to be run by only one operator.
The product to be packaged must be solid and weigh less than 8kg.
This machine is normally installed in workshops or industrial environments protected from the atmospheric
agents.
Use in areas with the risk of concentration of explosive gas from used materials is prohibited.
For such conditions, the machine installed must be built with a suitable protection degree.
The machine is equipped with security and control devices in order to avoid safety and health hazards to
persons and to comply with the pertinent laws in force.
The machine has to be used by one operator only.
T
he machine is manufactured in various models to satisf
y
the different market re
q
uirements.
‒ Model PACK 5040M-6050M.
Weldin
g
arm with manual movement.
‒ Model PACK 5040A-6050A.
Automaticall
y
activated welder arm.
English
13/56