Robopac PACK 5040M - About the Use; Recommendations for Operation and Use; Control Description

PACK 5040M/6050M
PACK 5040A/6050A
6. ABOUT THE USE
6.1. RECOMMENDATIONS FOR OPERATION AND USE
‒ Before performing any operation, the operator must make sure that he/she understood the "Instructions
for use".
‒ When using the machine for the first time, the operator must read the manual and identify the controls
and simulate some o
p
erations, es
p
eciall
y
the start-u
p
and shutdown.
| Important
Accident frequency derived from machine use depends upon many factors that cannot always be foreseen and
controlled. Some accidents can depend upon unforeseeable environmental factors; others depend especially
upon the user's behaviour. In addition to being authorised and appropriately informed, on first use personnel
must simulate some manoeuvres to identify the main commands and functions. Only carry out the operations
foreseen by the manufacturer and do not tamper with any device to obtain performances other than those
provided. Before use, check that the safety devices are correctly installed and efficient. Users, in addition to
striving to satisfy these requirements, must apply all the safety regulations and carefully read the descriptions
of the controls and start u
p
.
6.2. CONTROL DESCRIPTION
T
he
p
icture shows the
p
osition of the controls on the machiner
y
.
A) Master switch.
T
urns the
p
ower su
pp
l
y
on and off.
Position "0" (OFF) indicates that the machine is not
p
owered.
Position I (ON) indicates that the machine is on.
B) User interface: it is used to set or modif
y
the o
p
eratin
g
p
arameters of the machine.
For more details see the
p
ara
g
ra
p
h "Ke
y
board command descri
p
tion".
C) Multi-function command: used to activate the listed functions.
English
34/56