Robopac PACK 5040M - Machine Disposal and Scraping

PACK 5040M/6050M
PACK 5040A/6050A
| Important
Replace the worn parts with original parts.
Use the oils and greases specified in the manual. All these measures may guarantee the expected operating
and safety level of the machine.
‒ Silicone bar rubber (30x10 mm hs=30).
‒ Belt teflon (30x0,13 mm) adhesive on one side.
‒ Belt teflon (30x0,25 mm) adhesive on one side.
‒ Weldin
g
arm s
p
rin
g
.
‒ Weldin
g
wire.
‒ Pneumatic c
y
linder.
‒ Weldin
g
consent limit switch.
‒ Weldin
g
belt stra
p
.
‒ Furnace belt stra
p
.
‒ Thermofeeler.
‒ Resistance for tunnel.
‒ Gear motor (1/18).
‒ Gear motor (1/37).
‒ Activatin
g
the dc motor.
‒ Wire
p
ower su
pp
l
y
board.
9.5. MACHINE DISPOSAL AND SCRAPING
|
Important
These operations must be performed by specialised personnel in accordance with the standards in force on
workplace safety.
Do not scatter non biodegradable products, lubricant oil and non-iron components (rubber, PVC, resins, etc.) in
the environment.).
Discharge them in compliance with current regulations.
Useful information for the disposal of machines and machine parts.
Scrapping must be performed by qualified personnel.
Construction material:
‒ Low-densit
y
linear
p
ol
y
eth
y
len
e
(L.L.D.PE);
‒ Steel, aluminium and cast-iron;
‒ Co
pp
er and silver in the electrical/electronic com
p
onents
;
‒ Rubber, resins and fibres.
None of the component materials is harmful or poisonous.
Special care must be taken when disposing of leftover oil or grease from the motor reduction units.
Do not dum
p
these materials in the environment and do not dis
p
ose of them as household refuse.
English
53/56