Rockwell Automation Publication 2711P-UM008I-EN-P - February 2022 97
Chapter 3
Input Device Settings
You can adjust settings for input devices that are used by the terminal including
the keypad, touch screen, attached keyboard or mouse, and string entry popup.
Configure Keyboard or Keypad Settings
You can adjust settings for keys on the terminal or an attached keyboard.
1. Press Terminal Settings, then choose Input Devices>Keyboard/Keypad.
2. Press Repeat Rate to specify the number of times a key repeats itself per
second when held down.
Valid values are 0, 2…30. Values are device-dependent for an attached
keyboard, but typically the same.
3. Press Repeat Delay to select the time that elapses per second before a key
is repeated.
Values are device-dependent. Unsupported values are dimmed.
4. Press OK when done.
TIP This is an unsupported feature on Series B terminals (Series C for Stainless
Steel terminals). The Keyboard/Keypad configuration page is removed from
Series B terminals (Series S for Stainless Steel terminal).
To Next Page
Loading...
Need help?
General
