Rockwell Automation Publication 750-TG100B-EN-P - June 2019 281
Power Bay Components Chapter 9
8. Remove the clear-plastic connections cover from the front of the DC bus
conditioner.
9. Remove the two M6 x 12 mm torx screws that secure the +DC and -DC
cables to the +DC and -DC terminals on the DC bus conditioner,
respectively, and remove the cables.
10. Remove the M6 x 12 mm torx screw that secures the ground cable to the
GND (PE) terminal on the DC bus conditioner and remove the cable.
9,
10
M6 x 12 mm
T30
5 N•m (44 lb•in)
To Next Page
Loading...
