Remote Control
R&S
®
CMW500
172User Manual 1173.9463.02 ─ 02
Related common commands
The Event Status Register (ESR) can be queried using ESR? / XESR?.
The Event Status Enable (ESE) register can be set using the command *ESE / *XESE
and read using *ESE? / *XESE?.
See also Common Commands
6.6.3.4 STATus:OPERation
The STATus:OPERation register provides an overview of state transitions of the tasks
(e.g. GPRF:MEASurement1:POWer) by collecting the information of lower registers. The
STATus:OPERation register hierarchy is shown below. The paths can also be queried
via remote command, see SYSTem:HELP:STATus[:REGister] on page 258 and
SYSTem:HELP:STATus:BITS on page 257.
Fig. 6-1: STATus:OPERation register hierarchy
Status Reporting System
To Next Page
Loading...
