Rohde & Schwarz FSW-K40 - Page 109

Remote Control Commands for Phase Noise Measurements
R&S
®
FSW-K40
109User Manual 1173.9286.02 ─ 15
Manual operation: See "Range x - Range y" on page 59
8.9.2 Using Standard Limit Lines
CALCulate<n>:LIMit<k>:ACTive?.................................................................................... 109
CALCulate<n>:LIMit<k>:CLEar[:IMMediate]......................................................................109
CALCulate<n>:LIMit<k>:COPY........................................................................................109
CALCulate<n>:LIMit<k>:DELete......................................................................................110
CALCulate<n>:LIMit<k>:FAIL?........................................................................................ 110
CALCulate<n>:LIMit<k>:NAME....................................................................................... 111
CALCulate<n>:LIMit<k>:LOWer:STATe............................................................................111
CALCulate<n>:LIMit<k>:STATe.......................................................................................111
CALCulate<n>:LIMit<k>:TRACe...................................................................................... 112
CALCulate<n>:LIMit<k>:TRACe<t>:CHECk......................................................................112
CALCulate<n>:LIMit<k>:UPPer:STATe............................................................................ 113
CALCulate<n>:LIMit<k>:ACTive?
This command queries the names of all active limit lines.
Suffix:
<n>, <k>
.
irrelevant
Return values:
<LimitLines> String containing the names of all active limit lines in alphabeti-
cal order.
Example:
CALC:LIM:ACT?
Queries the names of all active limit lines.
Usage: Query only
Manual operation: See "Visible" on page 61
CALCulate<n>:LIMit<k>:CLEar[:IMMediate]
This command deletes the result of the current limit check.
The command works on all limit lines in all measurement windows at the same time.
Suffix:
<n>, <k>
.
irrelevant
Example:
CALC:LIM:CLE
Deletes the result of the limit check.
CALCulate<n>:LIMit<k>:COPY <Line>
This command copies a limit line.
Suffix:
<n>
.
Window
Using Limit Lines